Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TRANSM ISSION-KM SERIES 203 b. Carefully drive out the intermediate shaft while re- moving the intermediate and input shaft assemblies from the transmission case. I !. Using a large screwdriver, pry out the oil seal in the transmission case. Be careful not to damage the case or the adjacent bearing race . 12. Using a large screwdriver, pry out the oil seal in the transmission mounting flange. Be careful not to damage the case or the adjacent bearing race . 13. If inspection indicates additional disassembly is nec- essary, refer to the following sections. 10 Inspection I nput shaf t I. Check the gear teeth for excessive wear, corrosion and mechanical damage.

Check the teeth for galling, chips, cracks, missing pieces, distortion or discoloration from overheating. Replace the input shaft if the gears are dam- aged. 2. Inspect the input shaft bearings (Ffgure II) and seal surfaces for excessive wear, grooves, metal transfer and discoloration from overheating. Use a press 10 remove damaged bearings and to install new bearings. threaded holes in the flange and rotate the jackscrews to force the flange off the transmission case. Position the transmission with the input shaft up, then remove the flange from the transmission case . 9. Remove the output shaft (A, Fig ure 9) assembly from the transmission case and set aside for disassembly.

NOTE Shims behind the outer bearing race in the mountingflange determine bearing preload for the input shaft hearings. Save the shims and reinstall them if reusing the original parts. 10. The input shaft (B, Fi gur e 9) and intermediate shaft (C) assemblies must be removed together. Proceed as fol- lows: a. Insert a suitably sized bolt or rod through the hole in the rear of the transmission that supports the inter- mediate shaft ( figure 10). 3. Inspect the input shaft bearing outer races in the trans- mission case (A, Figure 12) and mounting flange (A, rig - ur e 13). If either race is damaged or excessively worn, remove it using a suitable puller.