58 CHA PTER THR EE condition. In addition, it can warn of developing prob lems inside the engine. If more thun a 43 psi. (300 kPa) differ- ence exists between the highest and lowest read ing cylin - ders on multicylindercngincs, the engine cannot be tuned to develop its maximum power. Specified cyli nder pres- sure is 390-470 psi (2700-3300 kPa). A compression read ing that is below the desi red com- pression pressure indicates that engine repair is required beca use of worn or broken rings, leaky or sticking valves or a co mbin ation of all. If the co mpression test readings arc lower than desired. isolate the cause by performing a wet c ompr ession test.
Remove the precombustion chamber (r ef er to Chapter Seve n). P erf orm the wet compr ession lest in the same way as the dry test. exce pt pour approximately one tablespoon of heavy eng ine oil (at least SAE 30) into the injector hole before performing Steps 7-9. If the wet compression read- ings are sign ificantly higher than the dry compression readi ngs, the cause for the low dry comp ression reading is probably worn or broken rings. If there is little difference between the read ings, the problem may be due to leaky or sticking valves or a faulty cylinde r head gasket.
l ft wo ad- ja cent cylinders on a multicylindereng ine read Iow an both tests, the head gasket may be leaking between the cylinders. Excessively high compression readi ngs indicate carbon buildup in the cylinder. CAUTIO.V Be sure to remove all the inj ectors 0 11 a mutticytinderengine to prevent inadvertent starting. 3. Remove the fuel injector( s) as described in Chapter Se ven. 4. Clean the injector hole. 5. Rotate the engine to b lowout any carbon. 6. Install the compression gauge and , if necessary, the adapter. 7. Crank the engine at least five turns or until there is no furthe r increase in compression shown on the tester gauge. 8. Record the read ing.
Relieve the tester pressure valve and remove the co mpression tester. 9. Repeat Steps ~- 8 for eac h remain ing cylinder on multi cylinderengines. NOTE A special Ope compression gauge and adapter is required to measure the compres- sion pressure in the cylin der. If the neces- sary compression test gauge is not available, have a diesel technician pe rform the test. va lve Clea ra nce Ad ju stm ent I. Be sure cooling water is connected to the engine. 2. Run the engi ne unt il it reaches normal operating tem- perature, then shut it off . Valve clearance is the gap between the end of the valve stem and the underside of the rocker ann.
A specified valve clearance must be maintained for the valves 10oper- ate as designed. Insufficient valve clearance will cause