OPERATION, LUBRICATION, MAINTENANCE AND TUNE-UP 59 @ VALVE CLEARANCE ADJUSTMENT (ALL MODELS) CAUTION Always rotate the crankshaft in the normal running direction (clockwise at crankshaft pulley); otherwise the water pump impeller will be damaged. Adjusting screw 4. Rotate the crankshaft nut clockwise so the 1T mark on the flywheel aligns with the reference pointer (B, Figure 31) on the clutch cover. The piston must be on its com- pression stroke. NOTE Some transmissions do not have an opening in the clutch cover. Remove the starter to view the timing marks on the flywheel (Fig- ure 33). NOTE When thepiston is on its compression stroke and at top dead center, both valves will be closed.
This can be determined by the posi- tion of the intake and exhaust rocker arms. Both should have free play, which indicates that the valves are closed. IDLE SPEED ADJUSTMENT (1GM AND 1GM10 MODELS) .. ,""\-"~' ,.....- .. - j- ..- l .. '--"~ 5. Measure the clearance between the rocker arm and valve stem (Figure 34). Correct valve clearance is 0.2 mm (0.008 in.). 6. If the clearance is incorrect, loosen the locknut, then rotate the adjusting screw on the rocker arm (Figure 34). Hold the adjusting screw, then tighten the locknut. Re- check the valve clearance. 7A.
2GM and 2GM20 engines-Rotate the crankshaft 360 0 so the 2T mark on the flywheel aligns with the refer- ence pointer (B, Figure 31) on the clutch cover. The pis- ton for number 2 cylinder must be on its compression stroke (see preceding NOTE). Perform Steps 5 and 6. 7B. 3GM, 3GM30, 3HM and 3HM35 engines-Rotate the crankshaft 240 0 so the 3T mark on the flywheel aligns with the reference pointer (B, Figure 31) on the clutch cover. The piston for number 3 cylinder must be on its compression stroke (see preceding NOTE). Perform Steps 5 and 6. 8. Reinstall the rocker arm cover. Idle speed screw rough engine operation and possible engine damage, such as burnt valves.
Excessive valve clearance will reduce en- gine performance. The recommended interval for valve adjustment is after every 300 hours of operation. How- ever, it is a good practice to check the valve clearances during each tune-up. The engine must be cold when adjusting valve clear- ance. On multicylinderengines, the cylinder nearest the flywheel is the number one cylinder. 1. Remove the rocker arm cover as described in Chapter Five or Six. 2. Observe the flywheel (A, Figure 31) through the open- ing in the clutch cover. A cylinder is at top dead center if the mark on the flywheel is aligned with the reference pointer (B) on the clutch cover. 3.
Rotate the crankshaft with a wrench on the crankshaft pulley retaining nut (Figure 32). Idle Speed Adjustment The correct idle speed is 825-875 rpm. Refer to the fol- lowing procedure to adjust the idle speed. 1. Run the engine until it reaches normal operating tem- perature. 2. Place the transmission in neutral. 3. Loosen the jam nut on the idle speed screw (Figure 35 or Figure 36).