64 CHAPTER FOUR NOTE In some instances. such as to pre vent rust for mation. it may be de sirable to j ill the sea- water cooling system with an antifreeze so- lution. Ref er to the following section in this chap ter. 7. If the seawater cooling system was drained, remove the seawater pump impe ller as described in Chapter Eight . Lubricate the impeller with dishwashing soap . then install the impeller in the pump housing. Assemble the pwnp. but do not lighten the cover retaining screws. NOTE Make a highly visible sign as a reminder that the seawater pump is inoperable. At- tach the sign to the controls. 8. Apply lubricant to the control cables and all linkage pivot points. 9.
Loosen belt tension for the pump and alternator drive belts . 10. Seal or cover all engine openings to prevent the en- trance of water, din or debris. Make a list of all the sealed locations to be sure they are all uncovered whe n returning the engine to service. II . Wipe any d in or co rrosion off the engine and trans- mission, then use a rag to apply oil or a rust inhibitor to all engine surfaces. 12. Fill the fue l tank so less con densation will fo nn. Add a good -quality antibacterial additive (biocide) and fuei stabilizer to the fuel tank . i3 . Remove the battery from the boat.
Tape the vent holes closed and clean the battery case with a baking soda solu- tion to remove any traces of corrosion and acid, then rinse with cold water. Check the electrolyte level in each cell and top olTwith distilled water as required. Cover the ter- minals with a light coat of petrol eum je lly. Store the bat- tery in a cool, dry place. The following procedures are designed to help prevent unnecessary engine damage during winter storage . To ensure that the coo ling system is completely drained, it may be necessary to readj ust the pos ition of the engine to drai n all water. It is possible that some water will remain in the system.
Filling it with an antifreeze solution will protect the sea- water cooling system. NOTE Remove the battery from storage every 30-45 days. Check electrolyte level and slow-charge f or five or six hours at 6 am ~ peres. Seawat er Cooling Sys tem COO U :'Ii G SYSTEM DRAIl'lI:'liG I. Place a suitable container under each drain, if space penn its. This will prevent water from draining into the bilge. The engine seawater cooling system must be prope rly dra ined for storage during the winter months in areas where t emperatu res fall below 32° F (0° C) . If it is not, the engine block or cooling system may be cracked by the ex- pansion of frozen water.
NOTE if no water flows from a drain, check the drain to make sure it is not obstructed or plugged.