Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

SI:-IGLE-CYLINDER Ei'iG I:-IES 83 5 Oil ring go. Expansion ring go. UfY 40. Place the feeler gau ge alongside the ring all the way into the groove. If the measurement is nOI withi n specifications (Table I), either the rings or the ring grooves are worn. Inspect and rep lace them as required. 3. Check the side clearance of the rings as shown in Fig. 4. Use a ring expander tool (Ftaure 41) to carefully in- stall the oil control ring, then the compression rings. The oil ring consists oftwo pieces, the oute r ring and the inner expansion spring. Assemb le the oil ring on the piston so the expansion spring gap is on the opposite side of the pis- ton from the ring end gap. See Fig u l"e 42.

The second compression ring is tapered while the top compression ring has a barrel face. The top of each compression ring is marked and must face toward the piston crown . NOTE If the cylinder has not been rebared, check the gap at the bottom of the ring travel, Connecting Rod Inspection Have the connecting rod checked for stra ightness by a dealer or machine shop. where the cylinder is the least worn. The piston pin end of the connecting rod is equipped with a bushing. Refer to Table I for bushing spec ifica- tions. If bushing replacement is requi red, a press is neces- sary to remove the old bushing and install a new bushing. The oil holes in the bushing and connecting rod must align.

Ream the bushing to obta in the desi red clearance in Table I. 2. Measure the ring gap with a feeler gauge as shown in Figure 38. Compare the measurement with specifications in Tab le I. If the measurement is not within specification. the rings must be replaced as a set. Check the gap of new rings as well. If the gap is too small. file the ends of the ring to correct it (F igure 39).