84 CHAPTER FIVE Scale / Second ring 12{)° Top ring Connecting Rod Bc arin~ Clearance Measurement I. Place the connecting rod and uppe r bearing half on the connecting rod journal. 2. Cut a piece ofPla stigagc the width of the bearing ( "' i~ ure 43). Place the Plastigagc on the journal. then install the rod cap and bearing. Be sure to install me cap so the marks on the cap and rod arc on the same side (Fig u re. U ). Piston/Connecting Rod Installation 1. Rotate the crank shaft so the crankpin is at bottom dead center. ,VOTE Do not place Pl a_~/iKage owr the joum aloil hole. 2. Make sure the ring gaps are positioned as she ..... n in Ffgurc 46. 3.
Immerse the entire piston in clean engine oil. Coal the cylinder wall with oil. 3. Tighten the connecting rod cap to the specification in T abl e 2. Do not rotate the crankshaft while the Plastigagc is in place. 4. Remove the connecting rod cap. To determine bea ring clearance. compare the width of the llattcncd Plasugagc to the markings on the envelope (F i~ u n' 45). If the clear- ance is excessive, have the crankshaft reground and install undersize bearings. 4. Install a piston ring compressor around the piston nngs. CAUT ION Use ex treme C1II 1' in Step 5 to prevent the connecting rodfrom nicking the crankshaft journal.