Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

SINGLE-CYLINDER ENGINES 85 with clean engine oil. Place the bearings in the con necting rod and cap. 7. Pull the connecting rod and bearing into position against the crankpin. Lightly lubricate the connecting rod bolt threads with engine oil. 8. Install the connecting rod cap. Make sure the rod and cap are properly aligned, Install the bolts finger-tight. 9. Tighten the cap retaining bolts to the specifications in Table 2. 10. Check the connecting rod side playas described un- der Piston/Connecting Rod Removal in this chapter. 5 11. Reassemble the engine by reversing the disassembly procedures.

TIMING GEAR CASE The timing gearcase covers the camshaft and crankshaft gears and the oil pump (Figure 48). The timing gcarcasc also contains the governor mechanism and serves as the mounting location for the fuel injection pump. A ball bearing in the timing gearcase supports the outer end of the crankshaft. Ca mshaft gear Cranks haft gear To remove and reinstall the timing gearcase, proceed a follows : 1. Disconnect the negative battery cable. 2. Remove the alternator as described in Chapter Eight. 3. Remove the oil filter. 4. Detach the control cables from the speed control lever and the stop lever (Figure 49). 5. Remove the fuel injection pump as described in Chap- ter Seven.

Fuel injection drive cam Governor flywe ight ~iҐm'lf~ 0 11 pump gear NOTE If a suitable tool is not available to hold the crankshaft pulley when unscrewing the re- raining nut. remove the starter and prevent flywheel rotation by inserting a screwdriver into the ring gear teeth. 6. Remove the crankshaft pulley retaining nut. Use a suit- able puller to remove the crankshaft pulley (Figure 50). Remove the drive key from the crankshaft. 7. Remove the water pump as described in Chapter Eight. 8. Remove the manual starter cover (Figu re 51). 9. Remove the setscrew in the end of the camshaft (A, Figure 52), then remove the manual starter drive pin (B). 5.

Position the piston so the numbered side of the rod (Figure 44) faces towa rd the camshaft side of the engine. Insert the piston/connecting rod assembly into the cylin- der (Figure 47). Lightly tap on the piston crown with a wooden hammer handle to insert the piston. Make sure the rod does not bang against the crankshaft. 10. Remove the timing gearcase (Figure 53). II. Remove the gasket and any residue from the gearcase and crankcase surfaces. 12. If crankshaft or starter seal replacement is necessary, proceed as follows: 6. Clean the connecting rod bearings carefully, including the back sides. Coat the crankpin joumal and bearings