86 CHAPTER FIVE . a. Pry the old seal from the gcarcasc with a large screwdriver. Work carefully to prevent damage to the gearcase seal surface, b. Clean the seal recess in the cover with solvent and blow it dry with compressed air. c. Apply gasket scaler 10the periphery of the seal. d. Position a new seal in the cover recess with its open end facing the inside of the gcarcasc. Drive the seal into place with a suitably sized seal driver or socket . 13, If crankshaft bearing replacement is necessary, pro- ceed as follows: a. Refer 10 Chapter Seven to remove the governor shaft from liming gcarcasc. b. Pry the seal from the gearcasc with a large screw- driver.
Work carefully to prevent damage to the gcarcasc seal surface. c. Drive or press out the bearing (Figure 54). Force the bearing toward the inside of the gearcase. d. Clean the seal and bearing recesses in the cover with solvent and blow them dry with compressed air. e. Drive or press in a new bearing until the bearing scats in the recess in the gearcase. g. Position a new seal in the cover recess with its open end facing the inside of the gcarcasc. Drive the seal into place with a suitably sized seal driver or socket. h. Refer to Chapter Seven to reinstall the governor shaft. 14. Reverse the removal procedure to reinstall the timing gearcase.
Tighten the gcarcasc retaining screws to the specification in Table 2. .' LUBRICATION SYSTE.\ . Refer to Chapter Two for lubrication system operation, diagrams and oil pressure test. Oil Pump f. Apply gasket sealer to the periphery of the seal. The engine oil pump is mounted on the front (timing gear) side of the cylinder block (Fig ure 48).