Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

SINGLE -CYLINDER ENGINES 87 5 Remo val a nd installation 2. Remove the governor thrust washer (Figure 55), thrust bearing (F fg ure 56) and thrust sleeve (Figure 57) from the crankshaft. I. Remove the tim ing gearcase as previously described. 3. Using a suitable tool (if available, Yanmar special tool 124085-92700), unscrew the crankshaft nut (A, Figure 58). 4. Remove the governor flyweight assembly (B, Figure 58). NOTE Early model engines may be equipped with a nut on the oil pump shaft. 5. Early models -Unscrew the oil pump nut. To prevent the pump gear from rotating, insert an Allen wrench into a pump mounting screw through a hole in the oil pump drive gear. 6.

Reach through the holes in the oil pump gear and un- screw the pump retaining screws (Figu re 59). 7. Remove the oil pump and gasket. 8. Clean any gasket residue from the oil pump and en- gtnc.