Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

88 CHAPTER FIVE Inner rotor / J ~ Outer rotor ;;~:J-k';:- - Feeler gauge / 9. Installation is the reverse of removal. Tighten the oil pump retaining screws to the tightening torque specified in Tabl e 2. Make sure the governor flyweight assembly is positioned on the locating pins (Figure 60). Tighten the crankshaft nut to the torque specified in Table 2. / / Disassembly, inspection and reassembly 2. Lift out the inner and outer pump rotors (F igure 62). 1. Remove the oil pump cover (Fig ure 61). 7. Measure the clearance between the outer rotor and the pump body (Figur e 64). Compare the measurement with specifications in Table I. 3.

Thoroughly clean all parts in solvent and dry with compressed air. 4. Check the drive spindle and pump rotors for signs of wear, scoring or damage. Rep lace damaged parts. 8. Place a straightedge across the pump body. Measure the side clearance between the rotors and straightedge with a flat feeler gauge (Fig ure 65). Compare with speci- fications in Table I. NOTE Replace the oil pump as a unit if any parts are damaged. 9. Measure the diameter of the inner rotor shaft. Measure the shaft bore of the pump body. Calculate shaft clearance and compare it with specifications in Tab le 1. 5. Reinstall the inner rotor in the pump body. Reinstall the outer rotor in the pump body. 10.

If any clearance measured in Steps 6-9 is not within specification, replace the pump. Individual components are not available. The pump must be replaced as a unit. 6. Measure the clearance between the inner rotor tip and outer rotor tip (Figure 63). Compare the measurement with the specification in Tab le 1. 11 . When reassembling the oil pump, make sure to lubri- cate the rotors, body and shaft with engine oil.