58 SEBU7901-01 Maintenance Section Cooling System Coolant (ELC) - Change 5. Loosen the cap for the coolant recovery tank slowly in order to relieve any pressure. Remove the cap for the coolant recovery tank. i02070355 Cooling System Coolant (ELC) - Change 6. Pour coolant into the coolant recovery tank until the coolant reaches the “COLD FULL” mark. DO NOT fill the coolant recovery tank above the “COLD FULL” mark. SMCS Code: 1350-070; 1395-044 Clean the cooling system and flush the cooling system before the recommended maintenance interval if the following conditions exist: 7. Clean the cap for the coolant recovery tank. Install the cap for the coolant recovery tank. 8. Start the engine.
Inspect the cooling system for leaks and for proper operating temperature. The engine overheats frequently. Foaming of the coolant Engines that are Not Equipped with a Coolant Recovery Tank The oil has entered the cooling system and the coolant is contaminated. NOTICE Fill the cooling system no faster than 19 L (5 US gal) per minute to avoid air locks. The fuel has entered the cooling system and the coolant is contaminated. Note: When the cooling system is cleaned, only clean water is needed when the ELC is drained and replaced. 1. Fill the cooling system with coolant/antifreeze.
Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” topic (Maintenance Section) for more information on cooling system specifications. Do not install the cooling system filler cap. Note: Inspect the water pump and the water temperature regulator after the cooling system has been drained. This is a good opportunity to replace the water pump, the water temperature regulator and the hoses, if necessary. 2. Start the engine and run the engine at low idle. Increase the engine rpm to high idle. Run the engine at high idle for one minute in order to purge the air from the cavities of the engine block. Stop the engine. Drain 3. Check the coolant level.
Maintain the coolant level within 13 mm (.5 inch) below the bottom of the pipe for filling. Maintain the coolant level within 13 mm (.5 inch) to the proper level on the sight glass (if equipped). Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pres- sure. 4. Clean the cooling system filler cap. Inspect the gasket that is on the cooling system filler cap.
If the gasket that is on the cooling system filler cap is damaged, discard the old cooling system filler cap and install a new cooling system filler cap. If the gasket that is on the cooling system filler cap is not damaged, perform a pressure test. A 9S-8140 Pressurizing Pump is used to perform the pressure test. The correct pressure for the cooling system filler cap is stamped on the face of the cooling system filler cap. If the cooling system filler cap does not retain the correct pressure, install a new cooling system filler cap. 1. Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure.
Remove the cooling system filler cap. 2. Open the cooling system drain valve (if equipped). If the cooling system is not equipped with a drain valve, remove the cooling system drain plugs. Allow the coolant to drain. NOTICE Dispose of used engine coolant properly or recycle. Various methods have been proposed to reclaim used coolant for reuse in engine cooling systems. The full distillation procedure is the only method acceptable by Caterpillar to reclaim the used coolant. 5. Start the engine. Inspect the cooling system for leaks and for proper operating temperature.