Lithium-Ion Battery Applications 195 to understand the capability of the lithium-ion battery cells to accept frequent rapid charg- ing, otherwise the life of the battery could be prematurely limited. However, by including frequent in-service charging opportunities it may be possible to reduce the overall size, and therefore, cost of the battery. The overall size of the battery will vary depending on the route, usage, and specific requirements but an all-electric bus could have a battery any- where from 75 kWh up to 300 kWh and depending on the vehicle electrical architecture design will be at least 350 V but more likely will operate in the 650 V range.
One other aspect should be mentioned here, the size of the battery is related to the distance the bus needs to travel. For instance, if the bus integrates a battery that can accept frequent fast charging, the battery can be of smaller size, both physically and energy-wise. This means a lower cost and lighter battery can be used in place of a larger, heavier battery. However, this is only effective if the battery chemistry can accept frequent fast charges without degrading the performance over its life ( Figure 18 ). Hybrid buses include an electric battery in addition to either a liquid propane gas (LPG), diesel, fuel cell, or other propulsion engine.
In this case, just like in the automobile hybrid, the battery will be much smaller than a fully electric bus battery but will likely still be much larger than an automotive-type HEV battery. In addition to buses, much of the rail transportation includes some form of electrification. For many years, large diesel-powered locomotives have integrated large capacity lead acid batteries to create diesel-hybrid locomotives. Today, some reports indicated that as much as 50% of the global light rail is powered by electricity. Some of these are integrating lithium- ion batteries in order to reduce emissions and improve performance. There are also some very Figure 18 New Flyer Xcelsior electric bus.