D1146/D1146TI/DE08TIS MAINTENANCE MANUAL z Rocker arm shaft diameter With an outside micrometer, measure the rocker arm shaft diameter at the point where the rocker arms have been installed. Replace the rocker arm if the amount of wear is beyond the specified limit. 2) Rocker arm z Visual check Visually check the face of the rocker arm in contact with the valve stem end for scores and step wear. If the wear is small, correct it with an oil stone or grinding paper of fine grain size. Rocker arm with a considerable amount of step wear should be replaced.
z Rocker arm bushing diameter Measure the inside diameter of the rocker arm bushing with an inside micrometer or vernier calipers, and compare the measured values with the rocker arm shaft diameter. If the clearance exceeds the limit, replace M1087 either bushing or shaft, whichever worn more. 55 Printed in Jan. 2001 PS-MMA0415-E1A Standard Limit φ23.978 ∼ φ23.959 mm φ23.75 mm Standard Limit 0.020 ∼ 0.093 mm 0.3 mm or less