D1146/D1146TI/DE08TIS MAINTENANCE MANUAL 3) Tappet and push rod z Clearance Measure the clearance of the tappet and tappet holes of the cylinder block. If the value is beyond the specified limit, replace tappets. z Visual check of tappet Visually check the face of the tappets in contact with the cam for pitting, scores or cracks, and replace if severely damaged. If the amount of cracks or pitting is small, correct with an oil stone or grinding paper. z Outside diameter of tappet With an outside micrometer, measure the tappet outside diameter If the measured value is beyond the limit, replace tappets. z Push rod run-out Use a feeler gauge to measure the push rod run-out.
Roll the push rod along a smooth flat surface as shown in the figure. M1084 feeler gauge 56 Printed in Jan. 2001 PS-MMA0415-E1A Standard Limit 0.035 ∼ 0.077 mm 0.15 mm Standard φ19.944 ∼ φ19.965 mm Limit 0.3 mm or less