D1146/D1146TI/DE08TIS MAINTENANCE MANUAL 4) Reassembling rocker arm assembly Reassembling can be done in the reverse order of disassembling and following things should be heeded z Check the oil supply hole of rocker arm shaft for any clog and clean thoroughly. z Be careful not to occur any swap of position and reverse assembly. 3.2.4. Camshaft (1) Camshaft end play z Push the thrust plate toward the cam gear. z With a feeler gauge, measure the clearance between the thrust plate and camshaft journal. z If the end play is excessive, replace the thrust plate. Feeler gauge (2) Cam z Cam lobe height M1095 Use a micrometer to measure the cam lobe height and journal diameter.
If the measured number is less than the specified limit, the camshaft must replaced. z Cam surface 57 Printed in Jan. 2001 PS-MMA0415-E1A Standard Limit 0.28 ∼ 0.43 mm 0.6 mm Standard Limit Cam lobe height (C) Intake 49.15 mm 48.85 mm Exhaust D1146/TI : 49.32mm 49.00 mm DE08TIS : 49.35mm Cam journal diameter (A,B) φ57.86 ∼ φ57.88 mm φ57.52 mm