D1146/D1146TI/DE08TIS MAINTENANCE MANUAL Compare the two values obtained through measurement of connecting rod bearing inside diameter with the outside diameters of crankshaft pins to determine the oil clearance. specified range, have the crankshaft z If the clearance deviates from the journals and pins ground and install undersize bearings. 3) Oil clearance between crankshaft and bearing (Method 2 : plastic gauge) z Assemble the crankshaft on the cylinder block and put plastic gauge on the journal and pin of crankshaft and then after assembling bearing cap, tighten the bolts at the specific torque.
Again after disassembling the bearing cap by removing the bolts, take out the flatted plastic gauge and measure the width of plastic gauge by means of plastic gauge measuring scale. This is the oil clearance. z The oil clearance too can be measured in the same manner 62 Printed in Jan. 2001 PS-MMA0415-E1A Standard Limit 0.034 ∼ 0.098 mm 0.25 mm