Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Turbocharger (equipped with Turbocharger Model) CAUTION While the engine is running and or just after it stops, the turbocharger is hot, be careful not to touch the turbocharger. NOTE Q When detaching and attaching the turbocharger assembly, be very careful not to allow dust, dirt and other foreign matters in the oil pipes. When the turbocharger assembly has been replaced, pour fresh engine oil through the oil filter port of the turbocharger. Before starting the engine, make sure that the air cleaner position. 1. Disconnect the intake hose (3). 2. Remove the oil switch (1). 3. Disconnect the pipe band (2). 4. Remove the exhaust manifold with turbocharger.

(1) Oil Switch (2) Pipe Band (3) Intake Hose W1021474 (3) Cylinder Head and Valve Cylinder Head Cover 1. Disconnect the breather hose (1). 2. Remove the cylinder head cover screw (2). 3. Remove the cylinder head cover (3). (When reassembling) Check to see if the cylinder head cover gasket is not defective. (1) Breather Hose (2) Cylinder Head Cover Screw (3) Cylinder Head Cover W1028468 Injection Pipes 1. Loosen the screws to the pipe clamp (1). 2. Detach the injection pipes (2). (When reassembling) Sent compressed air into the pipes to blow out dust. Then, reassemble the pipes in the reverse order.

(1) Pipe Clamp (2) Injection Pipe W1028640 S-28 KiSC issued 06, 2011 A Tightening torque Cylinder head cover screw 6.9 to 8.8 N·m 0.7 to 0.9 kgf·m 5.1 to 6.5 ft-lbs Tightening torque Injection pipe retaining nut 24.5 to 34.3 N·m 2.5 to 3.5 kgf·m 18.1 to 25.3 ft-lbs