05-E2B, 05-E2BG, WSM DIESEL ENGINE Cylinder Head and Cylinder Head Gasket (To be continued) 1. Loosen the pipe clamps (1), and remove the water return pipe (2). 2. Remove the cylinder head screw in the order of ( n or r ) to ( a ) and remove the cylinder head. 3. Remove the cylinder head gasket. 4. Remove the O-ring. (Carbon gasket type only.) NOTE Q Material of cylinder head gasket has been changed from carbon to metal. When replacing a cylinder head gasket, be sure to check with the following table and notes to chose a correct part. The carbon gasket can be used for the engine with the metal gasket specified using the O-ring (15221-33700).
The metal gasket cannot be used for the carbon type specification engine. Engine serial number and cylinder head gasket. (1) Clamp (2) Return Pipe (A) 3 Cylinder (B) 4 Cylinder n or r to a : To Loosen a to n or r :
To Tighten W10205250 S-30 KiSC issued 06, 2011 A Model Type of Gasket Parts Number Serial Number D905-E2B / E2BG Carbon gasket 16221-03310 4R0300 and below Metal gasket 1G032-03310 4R0301 and above D1005-E2B / E2BG Carbon gasket 16231-03310 4Z0452 and below Metal gasket 1G040-03310 4Z0453 and above D1105-E2B / E2BG D1105-T-E2B Carbon gasket 1E010-03310 4J0010 and below Metal gasket 1G063-03310 4J0011 and above V1305-E2B / E2BG Carbon gasket 16271-03310 5E0009 and below Metal gasket 1G078-03310 5E0010 and above V1505-E2B / E2BG V1505-T-E2B Carbon gasket 16292-03310 4E9455 and below Metal gasket 16394-03310 4E9456 and above Tightening torque Cylinder head screw 63.7 to 68.6 N·m 6.5 to 7.0 kgf·m 47.0 to 50.6 ft-lbs