Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Cylinder Head and Cylinder Head Gasket (Continued) (When reassembling the carbon gasket type) Replace the cylinder head gasket with new one. Securely fit the O-ring (1) to the pin pipe (2). When mounting the gasket, set it to the pin pipe holes. Take care not to mount it reversely. The cylinder head should be free of scratches and dust. Install the cylinder head, using care not to damage the gasket. After applying engine oil to the thread of screws, tighten them in several steps and specified sequence ( a ) to ( n or r ). Retighten the cylinder head screws after running the engine for 30 minutes and after cooling, adjust valve clearance.

(When reassembling the metal gasket type) Replace the cylinder head gasket with new one. When mounting the gasket, set it to the pin pipe holes. Take care not to mount it reversely. The cylinder head should be free of scratches and dust. Install the cylinder head, using care not to damage the gasket. After applying engine oil to the thread of screws, tighten them in several steps and specified sequence ( a ) to ( n or r ). NOTE Q Do not use O-ring on the pin pipe. It is not necessary to retighten the cylinder head screw and to readjust valve clearance after engine warmed up. (1) O-ring (2) Pin Pipe [A] Carbon Gasket Type [B] Metal Gasket Type W1030042 Tappets 1.

Remove the tappets (1) from the crankcase. (When reassembling) Visually check the contact between tappets and cams for proper rotation. If defect is found, replace tappets. Before installing the tappets, apply engine oil thinly around them. IMPORTANT Q Do not change the combination of tappet and tappet guide. (1) Tappet W10209700 Valves 1. Remove the valve caps (2). 2. Remove the valve spring collet (3), pushing the valve spring retainer (4) by valve spring replacer (1). 3. Remove the valve spring retainer (4), valve spring (5) and valve stem seal (6). 4. Remove the valve (7). (When reassembling) Wash the valve stem and valve guide hole, and apply engine oil sufficiently.

After installing the valve spring collets, lightly tap the stem to assure proper fit with a plastic hammer. IMPORTANT Q Don’t change the combination of valve and valve guide. (1) Valve Spring Replacer (2) Valve Cap (3) Valve Spring Collet (4) Valve Spring Retainer (5) Valve Spring (6) Valve Stem Seal (7) Valve W10211070 S-31 KiSC issued 06, 2011 A