. MAINTENANCE SERVICE PROCEDURE WARNING WATER SEPARATOR, DRAIN WATER (PAGE 3-70)". 4 - 25 CHECK ADDITIONAL WATER SEPARATOR, CLEAN INSIDE OF CASE (ONLY POOR FUEL ARRANGEMENT SPECIFIC ATION) The engine fuel piping system is under high internal pressure when the en gine is running. Always reduce the internal pres before draining water or replaci ng the element cup. Do not bring fire close. This engine consists of higher p recision parts than on the conventional f uel injection pump and n ozzle, so if dir t gets in, i cause problems. If there is any dirt stuck to the fuel line, use fuel to wa sh it off completely.
NOTICE When carrying out inspection a nd maintenance of the fuel system, the p articularly careful not to let any dirt o r dust get there is any dirt of dust around the fuel system, clean it off thoroughly w ith fuel before starting t he operation. To prevent dirt or dust from gett ing into the fuel circuit, remove all dirt an d dust from the surroun ding area before startin operation. Prepare a container to catch 1. Drain the water and fuel. For details, see "CHECK ADDITIO (ONLY POOR FUEL ARR 2. Loosen the ring nut (1), the 3. Pull screen (5) down to re holder (3). 4. Wash screen (5) in clean f 5. Check screen (5) and repl Wash the inside of case (2 Check case (2).
If it is scra the position of float (6) can 6. Wash the inside of water s 7. Install screen (5) to the wa 8. Replace O-ring (7) with a n 9. Tighten plug (4) and insert in case (2). Be careful not to let floa t (6) be at Tightening torque: 2.0 - 3.0 Nm (0.20 - 0.31 kgm, 1.4 - 2.2 lbft) 10. Install case (2) to the wate r separator holder (3), then tighten ri ng nut (1). Tightening torque: 23 - 27 Nm (2.4 - 2.8 kgm, 17.0 - 19.9 lbft) 11. After completing the inspec tion and cleaning, bleed the air. Use the same procedure a s when replacing the filter cartridge. For details of the method o f bleeding the air, see "REPLACE F UEL PRE-FILTER CA RTRIDGE (PAGE 4-6