. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING Komatsu genuine SUPERCOOLANT (AF-NAC) has the important function of preventing corrosion as well as preventing freezing.Even in the areas where freezing is not an issue, the use of antifreeze COOLANT is essential. Komatsu machines are supplied with SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for two years or 4000 hours. As a basic rule, we do not recommend the use of any COOLANT other than SUPERCOOLANT (AF-NAC).
If you use another COOLANT, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of COOLANT, always keep the density of COOLANT between 30% and 68%. When selecting COOLANT, investigate the lowest temperature in the past and decide the density for the COOLANT from the COOLANT density table below. When actually deciding the density for the COOLANT, set it about 10 ° C (18 ° F) below lowest temperature. The density must be over 30% at least.
If the density of obtained COOLANT is higher than the necessary density for lowest temperature, dilute it with adequate distilled water, and then fill it into the tank. If there is any unclear point, please contact your Komatsu distributor. 4 - 26 Just af ter the engin e is stopped, t he coolant is stil l hot and the i nternal pressure in t he radiato r is still high. If the radiator cap is remo ved under t his condition, you may scald yo urself. Accordingly, wait until the temperature goes down, the n loosen the cap slo wly to relea se the p ressur e. Start th e engine to clean th e cool ing system.
Whe n standing up from th e operator's seat or leaving the machine, set the work equipm ent lock lev er and parking brake l ever to th e LOCK positions. For the starting m ethod o f the e ngine, see "CHE CK BEFORE STARTING ENGINE ENGIN E (PAGE 3-8 4)" in th e OPERATION section of the manual Never go under the machi ne bod y while t he engin e is running. I t is very dangerous since the machine may move suddenly. and "STARTING Stop the machine o n level groun d whe n cleanin g or changing the coolant. Clean th e inside of the cooling s ystem, change the coolant according to the t able below.
In Coolant terval for cleaning inside of cooling system and changing antifreeze coolant Komatsu genuine SUPERCOOLANT (AF-NAC) Every two years or every 4000 hours whichever comes first