Komatsu — AFTER STARTING ENGINE

OPERATION MACHINE OPERATIONS AND CONTROLS Set the work equipment to the maximum right offset posture shown in the diagram on the right, then pull in the arm and check that it stops automatically when it comes close to the front right part of the bodywork. When it stops, move the arm out and cancel the auto- matic stop. Set the work equipment to the maximum right offset posture shown in the diagram on the right, then oper- ate the offset from the central position to the right and check that it stops automatically when it comes close to the front right part of the bodywork. When it stops, operate the offset to the left and cancel the automatic stop.

If any abnormality is found during the inspection, use the procedure in Item 3 to warm up the hydraulic oil, then carry out the inspection again. If there is still an abnormality, move the machine to a safe place, stop the engine, and contact your Komatsu dis- tributor for inspection and repair. 3-63