Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250

MAINTENANCE PROCEDURE MAINTENANCE NOTICE When cleaning the dust cup, do not remove evacuator valve (6). 3. Clean the inside of the air cleaner body and the dust cap. NOTICE Do not clean the inner element and use it again. When replacing the outer element, replace the inner ele- ment with a new part at the same time. 4. Direct dry compressed air (Max. 0.69 MPa (7 kgf/cm 2 , 99.4 PSI)) from the inside of the outer element along its folds. Then blow with air along the folds from the outside, and finally blow again from the inside. 1) Replace any outer element which has been cleaned 6 times or used for one year. Replace the inner ele- ment at the same time.

When cleaning the element, do not hit it or beat it against anything. Do not use any element if its folds or gasket or seal are damaged. 6. Set the cleaned outer element in position, then secure dust cup (3) with mounting clips (2). CAUTION When installing the dust cup, check O-ring (7) and replace it if there are any scratches or damage. 7. Press the button to return the red piston in the dust indicator to its original position. 4-20 2) Replace both the inner and outer elements if the dust indicator shows red immediately after the outer ele- ment is cleaned, even if the element has not been cleaned 6 times. 5.

After cleaning the element, shine an electric light bulb from the inside and check for small holes or thin parts on the element. If such parts are found, replace the ele- ment. NOTICE