Komatsu — Changing the oil in the transmission case, cleaning the strainer

Maintenance 5.8. Service procedure 5.8.8. Every 1000 service hours Maintenance for every 50, 100, 250 and 500 hours should be car- ried out simultaneously. Changing the oil in the transmission case, cleaning the strainer Immediately after the machine operation, the oil is hot. Therefore, wait for the oil to cool down before carrying out maintenance. Collecting container: min. 70 l capacity Refill capacity: see Section "5.4. Lubricants and operating means" on page 5-13. 1. Set the collecting container under drain plug (P), then remove drain plug (P) and drain the oil. To prevent the oil from pouring out suddenly, lossen and remove drain plug (P) gradually. 2.

After draining the oil, re-install drain plug (P). Tightening torque: 99 - 117 Nm 3. Set a collection container under the transmission oil filter. P 4. Remove transmission filter drain plug (1), drain the oil, then tighten the plug again. Tightening torque: 94 - 123 Nm 5. Remove the screws (2) and dismount the cover (3). Unscrew the strainer (5) from the cover (3). 1 6. Remove any dirt stuck to strainer, then wash it in clean diesel oil or flushing oil. If the strainer is damaged, it must be replaced. 3 7. Screw the spring (4) and strainer (5) into the cover (3). 2 Strainer tightening torque 95 - 120 Nm Replace the O ring on the cover, then re-install the cover. 2 3 4 5 5-61 WARNING WARNING