8.4 INSPECTION OF THE AIR INTAKE MANIFOLD 8.4 INSPECTION OF THE AIR INTAKE MANIFOLD Inspect as follows: 1. Visually inspect the manifold for any cracks, dents or other damage. Pay particular attention to the bolt areas. [a] If a crack is found, replace the intake manifold. [b] If no cracks are found, reuse the intake manifold. 2. Inspect the manifold mating surface for imperfections that could affect its sealing to the cylinder head. [a] If the manifold mating surface has imperfections, replace the intake manifold. [b] If the manifold mating surface is not damaged, reuse part. 3.
Laying a 0.5 cm (20 in) long by 6 mm (1/4 in) wide straight edge across the intake manifold, check the mating ports surfaces for warping. [a] If all port flange area measurements are less than 0.127 mm (0.005 in), the manifold is reusable and can be reinstalled with new gaskets. [b] If the manifold does not meet this requirement, the manifold must be replaced. All information subject to change without notice. 8-8 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION