Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 14.14 INSTALLATION OF VALVE, SPRING, SEAL AND VALVE CAP Install as follows: 1. Position the cylinder head on a work bench for valve installation, if removed. Lubricate the valve stems with clean engine lubricating oil and slide them into their respective valve guides and against the valve seats. If reusing valves, install them to their original positions. NOTE: Clean valve guide of old seal material and oil before installing the new seal. NOTICE: Ensure all valve spring seats have been installed before the valve stem oil seal is installed. 2. Install the valve spring seat over the valve guide. 3.

With the valve installed into the cylinder head, clean the valve guide and valve stem with brake cleaner. 4. Install the protective cap over the valve stem. NOTE: Do not coat valve stem or seal with oil prior to installation. 5. Install the valve stem seal over the protective cap. 6. Push the seal down on the valve stem using the seal installer (J–47490). When the installer tool contacts the cylinder head, the seal is correctly positioned. Be sure the installer is square against the cylinder head. Remove the seal installer and protector cap. 7. Install the valve spring and retainer. If reusing parts, install them to their original positions. NOTE:

Always install new valve stem locks when installing valves. 8. Using the valve spring compressor tool (J–47406), compress the valve spring only as much as required to install the valve locks. After installing the valve locks, rap the end of the valve stem sharply with a plastic mallet to seat the valve locks. NOTICE: Be sure the valve retainer is properly centered and aligned to avoid scoring the valve stem. Do not compress the spring any more than necessary to install the locks, to avoid damaging the oil seal. 9. Remove Compression test adaptor J-47411. 10. On the other three valves it may be necessary to repeat these steps for cylinders being worked on.

All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 14-29