IN CASE OF EMERGENCY 351 Front Jacking Location Rear Jacking Location When changing a front wheel, place the scis sor jack under the rear portion of the lower control arm as shown. Access the front jacking location from behind the front tire. Operate the jack using the extension with jack hook and the lug wrench. The extension tubes may be used but are not required. When changing a rear wheel, assemble the ex tension with jack hook to the jack and connect the extension tubes. Access the rear jacking lo cation from behind the rear tire. Place the jack under the Jack Lifting Point located on the rear axle lower control arm bracket.
Then locate the slot in the jack lift plate onto the rear axle Jack Lifting Point. Attach the extension with jack hook extending to the rear of the vehicle. Rear Jacking Location Connect the long extensions to the lug wrench. Before raising the wheel off the ground, make sure that the jack will not damage surrounding truck parts and adjust the jack position as required. CAUTION! Front Lifting Point 7 5. By rotating the lug wrench clockwise, raise the vehicle until the wheel just clears the ground surface. Rear Lifting Point WARNING! Raising the vehicle higher than necessary can make the vehicle less stable. It could slip off the jack and hurt someone near it.
Raise the vehicle only enough to remove the tire. Front Jacking Location