RAM 1500 — To Stow The Flat Or Spare

352 IN CASE OF EMERGENCY 6. Remove the lug nuts and pull the wheel off. Install the spare wheel and lug nuts with the cone shaped end of the lug nuts toward the wheel. Hand tighten the lug nuts with the vehicle lifted. To avoid the risk of forcing the vehicle off the jack, do not fully tighten the lug nuts until the vehicle has been completely lowered. 9. Lower the jack to its fully closed position. Stow the replaced tire, and secure the jack and tools in the proper location. 3. Remove the extension with the hook and reattach the short extension 5. Attach the lug wrench to the extension tubes with the curved angle facing away from the vehicle Ъ ­page­347.

Insert the extension tubes through the access hole between the lower tailgate and the top of the fascia/bumper and into the winch mechanism tube. 10. Adjust the tire pressure when possible. T O S TOW T HE F LAT O R S PARE 1. Lift the spare tire with one hand to give clearance to tilt the retainer at the end of the cable. 7. Lower the vehicle to the ground and finish tightening the lug nuts. Push down on the wrench handle for increased leverage. Tighten the lug nuts in a star pattern until each lug nut has been tightened twice Ъ ­page­431. If in doubt about the correct tightness, have them checked with a torque wrench by an authorized dealer or at a service station. 2.

Position the wheel behind the rear fascia/ bumper facing outward. Push the end of the winch’s cable, spring and steel sleeve through the back of the road wheel. Making sure the valve stem is facing the ground when the wheel is stowed. WARNING!­ A loose tire or jack thrown forward in a collision or hard stop, could endanger the occupants of the vehicle. Always stow the jack parts and the spare tire in the places provided. Reinstalling The Flat Or Spare Tire 8. If your vehicle is equipped with a wheel center cap, install the cap and remove the wheel blocks. Do not install chrome or aluminum wheel center caps on the spare wheel. This may result in cap damage. Reinstalling The Retainer