Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

HYDRAULIC SYSTEM (CONT’D) Figure PM-36 Replacing The Hydraulic Oil See the SERVICE SCHEDULE for the correct service interval. (See SERVICE SCHEDULE on Page 59.) WARNING Diesel fuel or hydraulic fluid under pressure can penetrate skin or eyes, causing serious injury or death. Fluid leaks under pressure may not be visible. Use a piece of cardboard or wood to find leaks. Do not use your bare hand. Wear safety goggles. If fluid enters skin or eyes, get immediate medical attention from a doctor familiar with this injury. 1 P-49434 W-2072-0496 Figure PM-37 Retract the arm and bucket cylinders, lower the bucket to the ground. Stop the engine. Open the tailgate.

Figure PM-35 1 P-49434A 1 Open the bleed valve (Item 1) [Figure PM-37] (early models) or loosen the plug (Item 1) [Figure PM-37] (later models) on the hydraulic pump. Close the valve or plug after a steady stream of hydraulic fluid free of any air bubbles drains from the valve. Tighten the bleed valve. P-49433 DO NOT RUN THE MACHINE WITH THE BLEED VALVE OR PLUG OPEN. Remove the drain plug (Item 1) [Figure PM-35] . Drain the fluid into a container. Run the machine through the hydraulic functions. Stop the engine. Check the fluid level and add as needed. Recycle or dispose of the fluid in an environmentally safe manner. Install the drain plug (Item 1) [Figure PM-35] .

Add the correct fluid to the reservoir until it is visible in the sight gauge. 325/328 Excavator Operation and Maintenance Manual 78