HYDRAULIC SYSTEM (CONT’D) Diagnostic Connectors Replacing The Hydraulic Filter Open the right side cover and tailgate. See the SERVICE SCHEDULE for the correct service interval. (See SERVICE SCHEDULE on Page 59.) Figure PM-39 Open the right side cover. Figure PM-38 1 1 1 1 P-49436 2 Diagnostic connectors (Item 1) [Figure PM-39] are located on the hydraulic circuitry. P-49435 The connectors can be used to check circuit pressures. Remove the hydraulic filter (Item 1) [Figure PM-38] . Clean the housing where the filter gasket makes contact. Put clean hydraulic fluid on the gasket. Install the new filter and tighten by hand only. WARNING Always clean up spilled fuel or oil.
Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-1285 Replacing The Case Drain Filter Open the tailgate. Remove the filter (Item 2) [Figure PM-38] . Clean the housing where the filter gasket makes contact. Put clean hydraulic fluid on the gasket. Install the new filter and tighten by hand only. 325/328 Excavator 79 Operation and Maintenance Manual