TRACK TENSION Rubber Track Clearance NOTE: The wear of the pins and bushings on the undercarriage vary with the working conditions and the different types of soil conditions. It is necessary to inspect track tension and maintain the correct tension. See the SERVICE SCHEDULE for the correct service interval. (See SERVICE SCHEDULE on Page 59.) Figure PM-42 Figure PM-41 10-15 mm P-49187 1 Figure PM-43 1 Track Frame P-49460 Raise one side of the machine approximately 100 mm using the boom and arm [Figure PM-41] . Track Roller Raise the blade fully and install jackstands under the blade and track frame (Item 1) [Figure PM-41] . Lower the boom until all machine weight is on the jackstands.
Track Stop the engine. B-14067 Measure the clearance at the middle track roller. Do not get fingers into pinch points between the track and the track roller. Use a bolt or a dowel of the appropriate size to check the gap between the contact edge of the roller and the top edge of the track guide [Figure PM-42] and [Figure PM-43] . WARNING AVOID INJURY Keep fingers and hands out of pinch points when checking the track tension. W-2142-0903 Rubber Track Clearance - 10-15 mm. 325/328 Excavator 81 Operation and Maintenance Manual 10- 15 mm