OPERATING PROCEDURE Make sure the load is evenly weighted and centred on the lifting chain, and is secured to prevent the load from shifting [Figure OI-96] . Lowering The Work Equipment With Engine Stopped If the engine stops, the work equipment (boom/bucket, attachments) can be lowered to the ground using hydraulic pressure which is stored in the accumulator. Lift and position the load. When the load is in position and tension is removed from the lift chain (secondary lift system), remove the secondary lift system. The console must be in the locked down position, and the key switch in the ON position. Figure OI-97 Use the control lever to lower the boom.
Operating On Public Roads When operating on a public road or motorway, always follow local regulations. For example: A slow moving vehicle (SMV) sign, or direction signals may be required. Check with services companies for underground electrical, water, gas lines, etc. work slowly in areas of underground powerlines. Lifting A Load N-15513 Do not exceed the rated lift capacity. See Lift Capacity on Page 101 and 109. The optional lifting clamp attachment gives the excavator a wider range of use and mobility for debris removal [Figure OI-97] . WARNING The lifting clamp cylinder is operated by the auxiliary hydraulic system. AVOID INJURY OR DEATH Do not exceed Rated Lift Capacity.
Excessive load can cause tipping or loss of control. The lifting clamp cylinder must be fully retracted when the machine is being used for excavating. W-2476-1003 The lift capacities are reduced by 122 kg if the excavator is equipped with the optional lifting clamp. Extend the bucket cylinder completely and lower the boom to the ground. Stop the engine. Wrap the chain assembly around the bucket mounting plate. Figure OI-96 B-19942 325/328 Excavator 43 Operation and Maintenance Manual