Cummins — Cummins CM2220 R2.8 Installation Guide R101B

Starting the Engine R2.8 CM2220 R101B Page 2-4 Section 2 - Start-Up and Troubleshooting Figure 7 - Install Pressure Cap Check the volume of fluid in the power steering pump reservoir. Fill the reservoir according to the manufacturer specifications. Power Steering Pump Fuel WARNING The fuel pump, high-pressure fuel lines, and fuel rail contain very high-pressure fuel. Do not loosen any fittings while the engine is running. Wait at least 10 minutes after shutting down the engine before loosening any fittings in the high-pressure fuel system to allow pressure to decrease to a lower level. Do not engage the starter motor for more than 30 seconds at a time.

Allow two minutes between cranking intervals. CAUTION After a new engine installation, filter change, or running the fuel tank dry, make sure there is fuel in the vehicle fuel tank. Unlock the manual priming pump handle by turning it counterclockwise . Pump the primer handle until resistance is felt and the handle can not be pumped anymore, approximately 140 to 150 strokes for dry filters. Lock the manual priming pump handle. If the engine does not start after 30 seconds of cranking, turn the key to the OFF position. Pump the priming pump again, repeating the previous steps until the engine starts.

When the engine does start, it can operate erratically and with increased noise levels for a few minutes. This is a normal condition as air is being removed from the system. NOTE: It is possible that Fault Code 559 can become active after fuel filter replacement, due to the air introduced in the system. Be sure to run the engine until the air is purged. Use an electronic service tool to clear the fault code. Figure 8 - Prime Fuel System To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com