Cummins — Cummins CM2220 R2.8 Installation Guide R101B

R2.8 CM2220 R101B Electrical System Section 1 - Installation by Subsystem Page 1-37 The starting motor connections are an M8 x 1.25 for the high amperage cable (2) and a 6.3 mm flat, male, push-on terminal (1) for the switch circuit, see Figure 1. The switch circuit should maintain the original vehicle interlock devices, such as brake and clutch switches, along with any transmission gear position switch. To adequately enable the starting motor to rotate the engine for starting, it is recommended that a 12 volt, 800 CCA, or greater, battery be used along with suitable starting motor cables sized to minimize electrical resistance in the circuit.

Figure 1 - Starting Motor Electrical Connections 1 Switch - male flat 6.3 mm [0.25 in] terminal connection, 50 amp pull-in and 20 amp hold-in current Torque Value: 23 N•m [ 204 in-lb ] 2 M8 x 1.25 stud, to battery positive post. Alternator The R2.8 CM2220 R101B Engine Kit includes an engine-mounted alternator, rated at 12 volt /120 amps. The connection on the alternator is a M8 stud for the high current cable, as shown in Figure 2. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com