Electrical System R2.8 CM2220 R101B Page 1-38 Section 1 - Installation by Subsystem Figure 2 - Alternator 1 Alternator to battery positive cable stud, 8 mm. Torque Value: 23 N•m [ 204 in-lb ] The engine_mounted alternator is rated at 12 volt /120 amps as shown in the performance graph, Figure 3. Figure 3 - Alternator Output Ampere 1 Cold 2 Hot - Alternator speed (rpm x 1000), drive ratio = 2.3 x rpm. Grounding The high amperage starting motor and alternator cannot share the same ground path to the battery negative post with the engine control module (ECM).
If done improperly, the voltage spikes from the high amperage starter and alternator will have an undesirable effect on the ECM, and thus the performance of the engine. It is very important the starting motor, alternator, ECM, and battery negative circuit be configured as shown in Figure 4. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com