R2.8 CM2220 R101B Electrical System Section 1 - Installation by Subsystem Page 1-39 Figure 4 - Electrical System Grounding 1 Alternator 2 Engine block 3 Starter motor solenoid/relay 4 Starter motor 5 Vehicle frame 6 Battery 8 Designates structural ground connection 7 ECM power and ground wires as part of supplied harness 9 CM2220 ECM 10 12 AWG ground cable. Wiring Harness There are two main components in the wiring harness – the engine compartment harness and the cab harness. A schematic of both components is available on QuickServe® Online (QSOL). Reference the R2.8 CM2220 R101B Wiring Diagram, Bulletin 5467560.
The engine-side wiring harness includes the connection to the ECM, power connection to the battery, grid heater, fan control wiring, and the interface connection to the cab-side harness. Figure 5 below identifies the component on the engine-side harness and the length of each lead, along with details of the 23 pin Deutsch pass-through connector. The Deutsch pass-through connector incorporates a gasket that is to be inserted on the engine bay-side of the connector to prevent dust from entering the cab area. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com