Bobcat Company 442 — Connecting Rod, Checking

RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-212 Connecting Rod, Checking (Cont'd) Figure 60-80-210 P-63060 Tighten the connecting rod cap nuts as follows [Figure 60-80-212] . P-63058 Initial Torque . . . . . . . . . . . . . . . . . . . . 22 ft.-lb. (30 N•m) 1st Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° 2nd Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .30° After pressing in the small end bushing, bore the bushing to the following dimensions [Figure 60-80-210] . Specifications: I.D. of Small End Bushing . . . . . . . . . . 1.338-1.340 inch.

(33.975 - 34.035 mm) Figure 60-80-211 P-63059 Install the correct cap on the correct rod [Figure 60-80- 211] . 442 Excavator 60-80-59 Service Manual