RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Connecting Rod, Checking (Cont'd) Figure 60-80-213 CD-15454 Measure the big end bore [Figure 60-80-213] . If the measurement is the same as the specific valve, the necessary preload on the bearing halves will be obtained. Specifications: Big End I.D. . . . . . . . . . . . . . . . . . . . 2.425 + 0.0008 inch (61,6 + 0,02 mm) Remove connecting rod cap. Install new bearing halves. Tighten the connecting rod cap nuts and tighten as listed in [Figure 60-80-212 on Page 59] . Measure the bearing halves: Big End Bearing I.D. . . . . . . . . . . . 2.2846 - 2.2862 inch. (58,03 - 58,07 mm) Each Undersize . . . . . . . . . . . . . . . . . . . .
. . . 0.010 inch. (0,25 mm) Limit For Undersize . . . . . . . . . . . . 2.2748 - 2.3157 inch. (57,78 - 57,82 mm) Radial Clearance Wear Limit . . . . . . . . . . . . . . . . .0.005 inch. (0,12 mm) Check the connecting rod, without bearing halves, on a connecting rod tester. Specifications: Parallel Check-Tolerance . . . . . . .0.002 inch. (0,05 mm) Over a Distance of. . . . . . . . . . . . . . 3.94 inch. (100 mm) Squareness Check-Tolerance . . . .0.002 inch. (0,05 mm) 442 Excavator 60-80-60 Service Manual