Bobcat Company 442 — Piston, Checking

RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-216 Piston, Checking Figure 60-80-214 P-63064 Measure the ring gap with a feeler gauge in the cylinder [Figure 60-80-216] . P-56781 Specifications: Wear Limit 1st Ring Gap . . . . . . . . . . . . . . . . 0.031 inch. (0,8 mm) 2nd Ring Gap . . . . . . . . . . . . . . . .0.098 inch. (2,5 mm) 3rd Ring Gap . . . . . . . . . . . . . . . 0.045 inch. (1,15 mm) Remove the piston rings from the piston [Figure 60-80- 214] . Remove the piston from the connecting rod. See Connecting Rod, Checking to check connecting rod specifications.

(See Connecting Rod, Checking on Page 60-80-58.) Figure 60-80-215 P-56782 Clean and inspect piston and piston ring grooves [Figure 60-80-215] . 442 Excavator 60-80-61 Service Manual