RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Piston Pin, Checking Figure 60-80-218 Piston, Checking (Cont’d) Figure 60-80-217 B-8230 P-56784 Check piston pin for wear [Figure 60-80-218] . Specifications: Pin O.D. . . . . .1.3383-1.3386 inch. (33,994-34,0 mm) Using new rings, measure the ring grooves using a feeler gauge [Figure 60-80-217] . Specifications: Wear Limit 1st Ring. . . . . . . . . . . . . . . . . . . . . . . Keystone Groove 2nd Ring . . . . . . . . . . . . . . . . . . .0.007 inch. (0.17 mm) 3rd Ring . . . . . . . . . . . . . . . . . . .0.004 inch. (0.10 mm) Measure the keystone groove with the keystone groove gauge [Figure 60-80-217] .
If a distance is present between the gauge and piston, the piston is serviceable [Figure 60-80-217] . If the gauge rests against the piston, replace the piston [Figure 60-80-217] . 442 Excavator 60-80-62 Service Manual