RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Piston Rings Installation Figure 60-80-219 P-56789 When installing the piston rings position them as listed below [Figure 60-80-219] . Figure 60-80-220 1 2 3 TS-1928A lst Ring - Is a trapezoidal ring, (Item 1) [Figure 60-80- 220] . It is installed on the piston with the facing the combustion chamber. 2nd Ring - Is a tapered compression ring (Item 2) [Figure 60-80-220] , which is installed on the piston with the mark TOP facing the combustion chamber. 3rd Ring - Is a bevelled edge slotted oil control ring (Item 3) [Figure 60-80-220] . The gap of each ring must be offset by 180 ° to the other ring. 442 Excavator 60-80-63 Service Manual