Bobcat Company 442 — Adjusting The Three Spool Control Valve Main Relief Valve

RELIEF VALVES (CONT’D) Adjusting The Three Spool Control Valve Main Relief Valve Testing The Three Spool Control Valve Main Relief Valve Stop the engine. Open the right side cover. Open the rear cover. Figure 20-30-4 Figure 20-30- 5 1 1 2 P-33371 P-33373 Install a 5000 PSI (345 bar) pressure gauge on the front test coupler (Item 1) [Figure 20-30-4] of the gear pump. Figure 20-30- 6 Start the excavator and warm the hydraulic oil to operating temperature. Move the engine speed control to the high speed position. 1 Raise the blade until the hydraulic cylinders are fully retracted and the relief valve opens. 2 Record the pressure.

The pressure at the gauge (Item 2) [Figure 20-30-4] should be 3335 PSI (230 bar). P-33374 Loosen the lock nut (Item 1) [Figure 20-30- 5] & [Figure 20-30- 6] . Turn the adjustment screw (Item 2) [Figure 20-30- 6] in to increase pressure and out to decrease pressure. NOTE: One quarter turn is approximately 700 psi (48 bar). Tighten the lock nut and retest the main relief valve. 442 Excavator 20-30-2 Service Manual