THREE SPOOL HYDRAULIC CONTROL VALVE (CONT’D) IMPORTANT Disassembly And Assembly (Cont’d) Figure 20-41-11 Do not use parts from one assembly to repair another assembly. Hydraulic and hydrostatic parts develop specific wear patterns. Used parts must be installed in the exact location that they were removed from. 1 I-2009-0284 1 P-35766 Remove the 3 O-rings (Item 1) [Figure 20-41-11] from the upperstructure swing/inlet section. Figure 20-41-12 Cut 2.0” 0.5625” dia. 0.750” 1.500” B-14674 To remove the spring retaining bolt from the spool, a holding fixture will have to be made from a 0.750 inch thick x 1.500 inches wide x 2.0 inches long (19 mm thick x 38 mm wide x 50 mm long) piece of hardwood.
Drill a 0.5625 inch (14 mm) hole in the center of the hardwood block. Cut the block lengthwise [Figure 20-41-12] . NOTE: Do not use anything other than hardwood blocks to grip the spool, or the spool will be damaged. 442 Excavator 20-41-5 Service Manual