Bobcat Company 442 — Load Sense Relief Valve Adjustment

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-31 Pump Testing (Cont’d) Figure 20-50-29 2 1 3 1 P-40583 2 Check the 13 mm nut (Item 1) [Figure 20-50-31] to be sure it is locked in place. P-40580 Adjust the flow at the hydraulic pump torque limiter by loosening the 27 mm nut (Item 2) [Figure 20-50-31] With an Allen wrench adjust the flow at low pressure . The flow should be 40 GPM (152 L/mm) on the flow tester (Item 1) [Figure 20-50-29] . When the proper flow is obtained, 37 GPM (140 L/min) at 1450 PSI (100 bar), lock the 27 mm nut (Item 2) [Figure 20-50-31] .

Turn the hydraulic tester flow control (Item 2) clockwise until the gauge (Item 3) [Figure 20-50-29] shows 1450 PSI (100 bar). The gauge (Item 1) [Figure 20-50-29] should show 37 GPM (140 L/min) which is flow at low pressure . NOTE: Changing the flow at low pressure (27 mm nut) will affect flow at high pressure (13 mm nut). Figure 20-50-30 Turn the hydraulic tester flow control (Item 2) clockwise until the gauge (Item 3) [Figure 20-50-29] reads 3480 PSI (240 bar). NOTE: Do not exceed 4350 PSI (300 bar) with the hydraulic tester or the pump will be damaged. The gauge should show 13 GPM (50 L/min) which is flow at high pressure. Adjust the flow at the hydraulic pump torque limiter.

Loosen the 13 mm nut (Item 1) [Figure 20-50-31] and with an Allen wrench adjust the flow at high pressure . 1 When the proper flow is obtained, 13 GPM (50 L/min) at 3480 PSI (240 bar), lock the 13 mm nut (Item 1) [Figure 20-50-31] . P-40582 Remove the dust cover (Item 1) [Figure 20-50-30] . NOTE: If adjustments were made to flow at high pressure verify the flow at low pressure . Install the protective cap on the hydraulic pump torque limiter. 442 Excavator 20-50-13 Service Manual