TRACK DAMAGE IDENTIFICATION (CONT’D) Causes Of The Damage: Cracks And Cuts On The Lug Side Rubber Figure 30-80-19 Damage: Figure 30-80-18 Crack at the edge of embedded metal Cut on lug side rubber PI-13051 When rubber tracks drive over sharp projections, intensive stress is applied to the lug side rubber surface, especially at the edges of embedded metals, causing cracks and cuts in the area around the embedded metals [Figure 30-80-19] . CD-13050 Sometimes cracks and cuts on the lug side rubber at the edges of the embedded metals can be observed [Figure 30-80-18] . Prevention: Replacement:
To avoid extensive stress applied to the lug root where metals are embedded, machine operators are requested to avoid driving over stumps and ridges. Basically, no replacement is required unless the cuts on the lug side rubber are discovered all around the edges of the embedded metals, as this will result in a complete cut off. 442 Excavator 30-80-8 Service Manual