Bobcat Company 442 — Abrasion Of The Track Roller Side

TRACK DAMAGE IDENTIFICATION (CONT’D) Causes Of The Damage: Abrasion Of The Track Roller Side Figure 30-80-21 Damage: Figure 30-80-20 Track Roller Abrasion PI-13053 The abrasion of the track roller side rubber surface occurs because of sand and gravel being clogged between the rubber and the outside surface of the track rollers. The stress pushes the sand and gravel against the side of the rubber track to cause the abrasion [Figure 30-80-21] . P-4383 The rubber surface on which track rollers run is gradually abraded. It will end in the exposure of the embedded metals [Figure 30-80-20] . The level of abrasion is highly dependent on terrain conditions.

A higher level of abrasion will occur when the rubber tracks are operated in fields covered with many stones and gravel. Small stones hardened with mud, stuck to the track rollers increase the abrasion level. After an extended period of abrasion, it will be more likely for exposed embedded metals to catch moisture through the inside steel cords, which can cause breakage of steel cords and separation of the metals from the rubber body. Replacement: It is recommended to replace the rubber track when more than half of the embedded metals are completely exposed. Prevention: After operation in wet fields containing many small stones, wash off the mud that is stuck to the track rollers completely.

When operating on gravel paths and stony grounds, machines should be driven slowly and the turning radius should be big enough to prevent stones and gravel from getting stuck to the track roller side rubber. 442 Excavator 30-80-9 Service Manual