Komatsu — Air Conditioner Maintenance

OPERATION Use Air Conditioner with Care Remark When running the air conditioner, always start with the engine running at low speed. Never start the air conditioner when the engine is running at high speed. It will cause failure of the air conditioner. If water gets into the control panel or sunlight sensor, it may lead to unexpected failure, be careful not to let water get on these parts. In addition, never bring any flame near these parts. For the auto function of the air conditioner to work properly, always keep the sunlight sensor clean and do not leave anything around the sunlight sensor that may interfere with its sensor function.

Ventilation If you smoke when the air conditioner is on, the smoke may start to hurt your eyes, so open the window and turn the lever to FRESH for a while to remove the smoke while continuing the cooling. When running the air conditioner for a long time, turn the lever to the FRESH position once an hour to carry out ventilation and cooling. Temperature Control When the cooler is on, set the temperature so that it feels slightly cool when entering the cab (5 or 6 °C (9 or 10.8 °F) lower than the outside temperature). This temperature difference is considered to be the most suitable for your health, so always be careful to adjust the temperature properly.

Air Conditioner Maintenance When carrying out inspection and maintenance on machines equipped with an air conditioner, carry out the inspection and maintenance according to the chart. For details, See “Check and Maintenance Air Conditioner” on page 3-43, “Check Air Conditioner Compressor Belt Tension, Adjust” on page 3-56, “Clean Air Conditioner Fresh/Recirc Filters” on page 3-68. When the air conditioner is not being used every day, to prevent loss of the film of oil at various parts, run the engine at low speed from time to time and carry out cooling or dehumidifying heating for several minutes. If the temperature inside the cab is low, the air conditioner may not work.

In this case, circulate fresh air to warm the inside of the cab. When the air conditioner switch is turned ON, the air conditioner will work. If any abnormality is detected in any equipment or sensor used on the air conditioner, “A/C Controller Error” is displayed on the air conditioner monitor screen. If “A/C Controller Error” is displayed, please ask your Komatsu distributor to carry out inspection and repair. PC200LC-8 2-105