OPERATION RADIO Control Panel 1. Power switch, Volume control knob, Balance control knob 6. Preset station buttons (1,2,3,4,5,6) 2. SEL button 7. Display 3. FM/AM selection button 8. Time reset button 4. Display selection button 9. Tuning button 5. AS/PS button Power switch, Volume control knob, Balance control knob Press this knob (1) to turn the power for the radio on. The frequency is displayed on display (7). Press the knob again to turn the power off. Turn the knob clockwise to increase the volume; press counterclockwise to reduce the volume. The range for the volume is VOL 0 - VOL 40. SEL button Each time this button (2) is pressed, the mode changes as follows:
VOL (volume) BAS (bass) TRE (treble) BAL (balance). The mode is displayed on display (7). For details of each mode, See “Controls of Radio” on page 2-108. FM/AM Selection Button (AM/FM) Press this button (3) to select the desired band. Each time the button is pressed, the band changes FM AM FM . . . Display Selection Button (TIME) On this machine, priority is given to the frequency display. When the frequency is being displayed, press button (4) and the display will show the present time for five seconds. After five seconds pass, the display returns automatically to the frequency display.
If any button other than TIME ADJ (H, M, ADJ) is pressed within five seconds, the display returns to the frequency display. For details of the method of adjusting the time, See “Controls of Radio” on page 2-108. 2-106 PC200LC-8