OPERATION MACHINE OPERATIONS AND CONTROLS Before Starting Engine Walk-Around Checks Before starting the engine, look around and under the machine to check for loose nuts and bolts, or leakage of oil, fuel, or coolant, and check condition of the work equipment and hydraulic system. Also check for loose wiring, play, and accumulation of dust at places with high temperatures. Remove any flammable materials from around the battery, engine, muffler, turbocharger, or other high temperature engine parts. Leakage of fuel or oil will cause the machine to catch fire. Check carefully, be sure to repair any problem, or contact your Komatsu distributor.
Perform the following inspections and cleaning every day before starting engine for the day's work. 1. Check for damage, wear, play in work equipment, cylinders, linkage, hoses. Check for cracks, excessive wear, play in work equipment, cylinders, linkage, and hoses. If any problem is found, repair it. 2. Remove dirt and debris from around the engine, battery, and radiator. Check for dirt accumulated around the engine and radiator. Also check for flammable material (dry leaves, twigs, etc.) around the battery, engine muffler, turbocharger, or other high temperature engine parts. If any dirt or flammable materials are found, remove them.
For the method of removing dirt from the radiator, see “Clean and Inspect Radiator Fins, Oil Cooler Fins, Aftercooler Fins, Fuel Cooler Fins, and Condenser Fins (Only Machines Equipped With Air Conditioner)” on page 3-65. 3. When using high-pressure steam (high-pressure machine washing) to remove dirt or flammable material and clean the heat exchange equipment (radiator, oil cooler, aftercooler, fuel cooler, air conditioner condenser), always keep the proper distance when washing. If steam washing is carried out from close range, there is danger that the internal fins of the heat exchange equipment may be deformed, leading to premature clogging or damage to the equipment. 4.
Check for coolant and oil leakage around the engine. Check for oil leakage from the engine and coolant leaks from the cooling system. If any problem is found, repair it. 5. Check for leakage from fuel line. Check that there is no leakage of fuel or damage to the hoses and tubes. If any problem is found, carry out repairs. 6. Check for oil leakage from hydraulic equipment, hydraulic tank, hoses, and joints. If any problem is found, repair the area where oil is leaking. 7. Check the undercarriage (track, sprocket, idler, guard) for damage, wear, loose bolts, or leakage of oil from rollers. If any problem is found, repair it. 8. Check for problems in handrails, steps, loose bolts.
If any problem is found, repair it. Tighten any loose bolts. 9. Check for problem in gauges, monitor. Check that there is no problem in the gauges and monitor in the operator's cab. If any problem is found, replace the parts. Clean off any dirt on the surface. 10. Clean, check rear view mirror. Check for damage to the rear view mirror. If damaged, replace it with a new mirror. Clean surface of the mirror and adjust angle so area at the rear can be seen from the operator's seat. 11. Seat belt and mounting clamps. Check for damage or wear to the seat belt and mounting clamps. If there is any damage, replace with new parts. 12. Check bucket with hook (if equipped) for damage.
Check for damage to the hook, guide, and hook mount. If any problem is found, contact your Komatsu distributor for repairs. 13. Inspection and cleaning of rear view camera. Check the rear view camera for any abnormality. If it is found defective, call your Komatsu distributor for repair. PC200LC-8 2-115