OPERATION Remark If transparent cap (2) is dirty or it is difficult to see the inside, clean transparent cap (2) when replacing fuel pre-filter cartridge (1). When the drain valve (4) has been removed during the cleaning operation, coat the O-ring with grease and tighten until it contacts the bottom. Adjustment of Drain Valve If drain valve (4) is stiff, coat the O-ring portion of the drain valve with grease to make the movement smooth. 1. Turn the valve (6) at the bottom of the fuel tank to the CLOSE position (S). 2. Set the container to catch the fuel under the pre-filter cartridge. 3.
Loosen drain valve (4), then drain all the water and sediment in the transparent cap (2) and also the fuel accumulated in filter cartridge (1). 4. Check that nothing more comes out from drain hose (3), then remove drain valve (4). 5. Coat O-ring portion (7) with a suitable amount of grease. When doing this, be careful not to let the grease get stuck to the drain valve water drain port (8) or drain valve thread (9). 6. Tighten drain valve (4) by hand until it contacts the bottom of transparent cap (2). 7. Remove the fuel container. 8. Turn the valve (6) at the bottom of the fuel tank to the OPEN position (O).
Remark When bleeding air, see “Replace Fuel Pre-Filter Cartridge” on page 3-62 or “Replace Fuel Main Filter Car- tridge” on page 3-75. PC200LC-8 2-117